800BMF

800BMF; inspired on the GK800RB amplifier, served as a Back/Rear Mount option in a full preamp version.

Make it growl, make it deep, make it clear. It’s all there!!

(!!Knobs Sold separately for the stacked controls!!)

 

Active controls:

-Stacked Bass/Treble

-Stacked Hi-mid/Lo-mid

-Volume with Contour switch (push-pull)

-Active Balance

 

Voltage: 9 to 27VDC  Current Draw: +- 5mAh (9v)

All our preamps are solderless

Instructions Manual

£169.00

Categories: ,

Description

The 800BMF is a full version of the 800BM preamp; it borrows the EQ section of the famous GK800RB amplifier and squeezes it into an onboard preamp, this time with a built-in Contour switch, on the Volume Control, for an increase in sound options.

The 800BMF differs from the 800BM by having an Active Blend and Master Volume control, making this a fully featured preamp.(not suitable for active/passive operation).

This tone stack has a very defined and clear tone to it. The EQ controls allow for some serious high-frequency power and a very deep bottom end, just like the amplifier it’s based on, allowing you to explore different tones directly from your instrument.

The Hi-mid and Treble controls are highly interactive; the same goes for the Lo-Mid and Bass controls and the overall sound is always very “cut through” and clear sounding.

The built-in Contour function works wonders at giving an instant new sound profile (think slap-switch), and it’s as easy as pulling up on the volume control to activate it and pushing down to deactivate it.

For a stripped-down version of the 800BMF, check the 800BM.

Treble: Boost and cut around 4khz

Hi- Mid: Boost and cut at around 1khz

Bass: Boost and cut at around 60Hz

Lo- Mid: Boost and cut at around 250Hz

Volume with built-in Contour switch (push-pull): EQ pre-shape (V)

Active Balance board: active blend control

Warranty and Conditions

Any of our products will be replaced / fixed and all expenses will be covered once it has been verified that the problem isn’t a result of bad handling or negligence on the owner’s part.

If the damage is due to negligence or wrong handling, the warranty is lost and a cost can occur for the devices repair (the shipping costs will not be covered in such cases).

Let's talk about your next piece of gear

Before committing, it is important that you let us know about your instrument’s specs (electronics / number of controls, etc.), as well as where you are writing from. Give us a shout and we will get back to you.